Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » Hold-down Clamps

What is the function of the pad on a hold-down pipe clamp?

The pads that are bonded to the inside of the hold-down clamps along the radius may either be 3/32” thick PTFE, 25% glass filled slide plates or ¼” thick belting material. These pads allow for movement of the pipe within the hold-down clamp.

Hydraulic Snubber Assemblies - Passive Supports
Hold Down Clamps with PTFE Liners
Related Articles RSS Feed
Where will the hold down supports be used?
Viewed 2777 times since Fri, Nov 25, 2011
How does one mount a pipe to the floor?
Viewed 5706 times since Tue, Nov 2, 2010
How do you predict the piping system movement? If I fail to get the correct travel and direction, will I end up damaging the snubber?
Viewed 3158 times since Thu, Nov 3, 2011
How do I clamp a pipe to a wall?
Viewed 5250 times since Wed, Feb 23, 2011
How do I anchor a pipe to exterior brick?
Viewed 4935 times since Thu, Jun 16, 2011
What are hold-down clamps?
Viewed 5386 times since Tue, Feb 1, 2011
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy