Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » Pipe Support Hardware

How do I weld an anchor rod to an embed plate?

The most common method of welding an anchor rod to an embed plate involves using pre-sized studs which have a flat surface of sufficient area that once welded in place would provide an indication of the load capacity.

Two 240 Inch x 12 Inch x 1/2 Inch Embed Plates
Two 240" x 12" x 1/2" Embed Plates

Related Articles RSS Feed
When do you use the u-bolt to guide the pipe?
Viewed 8571 times since Tue, Nov 2, 2010
What is an eye rod?
Viewed 5421 times since Tue, Nov 2, 2010
How much length adjustment of hanger rods are permitted in a turnbuckle?
Viewed 3527 times since Sat, Jun 9, 2012
What bonds PTFE?
Viewed 3654 times since Fri, Feb 11, 2011
Where are bearing plates typically used?
Viewed 3740 times since Wed, Dec 1, 2010
What is a roller hanger?
Viewed 4577 times since Tue, Nov 2, 2010
What is the purpose of a three bolt clamp?
Viewed 1268 times since Fri, May 16, 2014
Why does maximum temperature for a Figure 89 have a temperature limited to 650˚F?
Viewed 4085 times since Thu, Nov 3, 2011
What is a clevis and yoke?
Viewed 4160 times since Fri, Feb 11, 2011
When do you use a linked eye rod?
Viewed 5094 times since Wed, Feb 23, 2011
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy