Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » General Questions

What is the maximum spring rate decay in percentage required to replace it?

Per MSS the maximum deviation from the published spring rate for any spring would be +/-10%. Consequently any decay greater than 10% would be unacceptable.
Related Articles RSS Feed
Can the spring be re-calibrated?
Viewed 2924 times since Thu, Nov 10, 2011
What is the centerline in pipe supports?
Viewed 4779 times since Tue, Nov 2, 2010
Regarding various types of pipe clamp devices, are these devices also suitable for use with polymer material pipe?
Viewed 3370 times since Fri, Nov 25, 2011
What is marinite insulation block?
Viewed 6264 times since Thu, Oct 27, 2011
How do I figure out the length needed for a u-bolt rod?
Viewed 4117 times since Tue, Nov 2, 2010
How do you double nut a pipe hanger?
Viewed 3931 times since Wed, Jun 22, 2011
What factors go into calculating Pipe Thickness?
Viewed 1222 times since Fri, May 9, 2014
Where is a common area to find a piping deformation?
Viewed 1215 times since Fri, May 16, 2014
What is a pipe trunnion?
Viewed 32332 times since Tue, Nov 2, 2010
How do you define a hydro-test pressure based on design pressure?
Viewed 5004 times since Mon, Aug 12, 2013
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy