Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » General Questions

When you take a compression test to failure, what is the failure criteria?

The failure criteria is a permanent deformation greater than 3% is considered a failure for that particular batch.

Related Articles RSS Feed
Can you give examples of solids that are transferable via a pipe?
Viewed 2086 times since Mon, Jan 28, 2013
Where do you anchor piping?
Viewed 4244 times since Wed, Feb 23, 2011
What is an Inner Thrust Ring?
Viewed 1155 times since Fri, May 16, 2014
What is the difference between a snubber, sway brace and sway strut?
Viewed 6956 times since Fri, Jan 25, 2013
What are the basic steps when designing a spring hanger?
Viewed 1474 times since Fri, May 16, 2014
What do you use as a bonding material for the PTFE to the stainless steel or other hold down plates?
Viewed 3177 times since Fri, Nov 25, 2011
What does D.N.V stand for?
Viewed 1298 times since Fri, May 16, 2014
How do I get a pipe support custom made?
Viewed 4871 times since Wed, Feb 23, 2011
Can the load on the spring be lowered based on a spring can that is already designed and installed?
Viewed 2120 times since Fri, Jan 25, 2013
What is the maximum sag usually considered when designing a steel piping system?
Viewed 2603 times since Fri, Jan 25, 2013
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy