Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » General Questions

How do we inspect load cells and what is the criteria for their positioning?

A load cell is only the measuring device for calibration and it is used to test all our spring cans and constants.
Related Articles RSS Feed
What is the density of polyurethane?
Viewed 3745 times since Tue, Nov 2, 2010
What is the centerline in pipe supports?
Viewed 4771 times since Tue, Nov 2, 2010
What causes pipe vibrations?
Viewed 3820 times since Wed, Jun 22, 2011
Does an anchor restrict motion in all direction that is X-Y-Z directions?
Viewed 2804 times since Fri, Jan 25, 2013
What is cold expansion?
Viewed 1493 times since Fri, May 16, 2014
How do you calculate how much load a particular pipe support can take?
Viewed 5980 times since Thu, Jun 16, 2011
What is a pipe support?
Viewed 5950 times since Tue, Nov 2, 2010
Which standards are used when designing Constant Spring hangers?
Viewed 1099 times since Fri, May 16, 2014
What is a Pipe Spool?
Viewed 2320 times since Fri, May 16, 2014
What is the maximum sag usually considered when designing a steel piping system?
Viewed 2599 times since Fri, Jan 25, 2013
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy