Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » Multiple Categories

What are the basic steps when designing a spring hanger?

When designing a spring hanger, you want to consider the following:

1.) Where will the hangers be located?
2.) Calculate the hanger loads due to the piping weight
3.) Calculate the thermal movement of the piping at each hanger location
4.) Select your appropriate spring element / hanger type
5.) Check for any clearances around the structure and support. You want to make sure that there is enough space to fit your configuration. 
Related Articles RSS Feed
Regarding resilient support what does constant effort provide?
Viewed 1003 times since Mon, Jul 28, 2014
What does D.N.V stand for?
Viewed 1362 times since Fri, May 16, 2014
How do you tighten a spring can?
Viewed 4342 times since Thu, Jun 16, 2011
Can the spring be re-calibrated?
Viewed 2960 times since Thu, Nov 10, 2011
How do I remove travel stops in a spring hanger?
Viewed 5595 times since Thu, Feb 17, 2011
What coatings are applied to the spring and spring can to resist corrosion in marine environments?
Viewed 3198 times since Thu, Nov 10, 2011
What is an Inner Thrust Ring?
Viewed 1201 times since Fri, May 16, 2014
How do you check the alignment of the spring in the spring hanger?
Viewed 3535 times since Thu, Jun 16, 2011
When you take a compression test to failure, what is the failure criteria?
Viewed 2854 times since Thu, Nov 10, 2011
Will the load of fluid flowing through the pipe be considered as a varying load? or is that included in the basic piping weight?
Viewed 3038 times since Thu, Nov 10, 2011
Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy