Piping Technology and Products Logo

Piping Technology & Products

  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914

Home » Categories » General Questions

How do I figure out the length needed for a u-bolt rod?

When determining the required length of a u-bolt, one should provide a leg length which extends from the centerline of the pipe to end of the threaded portion, while still permitting a hexnut/locknut combination with full thread engagement.

Related Articles RSS Feed
What is a T-Bar?
Viewed 1302 times since Fri, May 9, 2014
What is burst testing?
Viewed 4345 times since Wed, Dec 1, 2010
How do you pre-insulate pipe?
Viewed 4238 times since Tue, Nov 2, 2010
What is a flow rate?
Viewed 2102 times since Mon, Aug 12, 2013
What is marinite insulation block?
Viewed 6516 times since Thu, Oct 27, 2011
How many pipe hangers do I need on my pipe?
Viewed 3752 times since Thu, Jun 16, 2011
What is galvanized coating?
Viewed 5551 times since Wed, Dec 1, 2010
What causes pipe vibrations?
Viewed 4001 times since Wed, Jun 22, 2011
Do you consider load variation at all when sizing constant supports?
Viewed 1180 times since Fri, May 16, 2014
What is a pipe support?
Viewed 6177 times since Tue, Nov 2, 2010

Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy