Piping Technology and Products Logo

Piping Technology & Products

 
  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914
 

Home » Categories » Slide Plates

How do you install slide plates?

For PTFE, 25% Glass Filled Slide Plates: Prior to Welding: Locate the slide plate base in the appropriate position on the existing steel surface. Place a protective covering on the PTFE, 25% glass filled. Where seal welding is not required, follow the diagram shown which indicates 1/8 inch thick fillet weld, 1 inch long every 4 inches around entire perimeter of the base. For welding, use GMAW 0.035 wire or SMAW 3/32 inch stick. Where full seal welding is required, use a similar pattern of welding until a full weld is obtained. This method will prevent damage to the PTFE, 25% glass filled. (A full weld will help prevent seepage of water between the slide bearing plate and the support structure.) Avoid overheating, which may destroy the bonding of the PTFE, 25% glass filled to the base plate. Installation in Concrete: Secure the top and bottom elements together with paper adhesive tape. Then attach the bottom element anchor bolts with wire to the form. After the bottom pour is made, repeat on top element. During the first expansive cycle, the tape will break. For Graphite and Bronzphite Plates - see link below:

Facebook


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy