Piping Technology and Products Logo

Piping Technology & Products

  Experienced Manufacturer of Pipe Supports since 1975.
Call Us: Phone: (713) 731-0030 Toll-Free: (800) 787-5914

Home » Categories » General Questions

How do you perform a burst test?

The burst test is primarily conducted on bellows. Normally, hydraulic pressure is slowly increased until failure occurs. Based on the burst test results, a safety factor is applied. This establishes the ultimate pressure rating.

Burst Testing
Burst Testing
Related Articles RSS Feed
What is a flow rate?
Viewed 2094 times since Mon, Aug 12, 2013
Is it possible that the rod/spring coming down from the spring support can be welded directly to the pipe in order to support it?
Viewed 1267 times since Fri, May 9, 2014
How do pipe supports reduce vibration?
Viewed 1796 times since Fri, May 16, 2014
How do I make a request for quotation?
Viewed 3702 times since Wed, Mar 23, 2011
What is the difference between a cold load and hot load with a variable spring?
Viewed 8697 times since Fri, May 16, 2014
What is a pipe trunnion?
Viewed 34649 times since Tue, Nov 2, 2010
Does change in density imply change in thermal conductivity?
Viewed 3080 times since Wed, Nov 23, 2011
What is STAAD analysis?
Viewed 3526 times since Thu, Nov 10, 2011
How do I figure out the length needed for a u-bolt rod?
Viewed 4234 times since Tue, Nov 2, 2010
What is a Pipe Spool?
Viewed 2543 times since Fri, May 16, 2014

Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows Metallic & Fabric Expansion Joints, Bellows | Sweco Fab ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields Pre-Insulated Pipe Supports, Slides, Guides & Anchors | Fronek Anchor/Darling
Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 E-MAIL: info@pipingtech.com

Copyright 2011 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy