| Home » Categories » General Questions |
How do you perform a burst test? |
The burst test is primarily conducted on bellows. Normally, hydraulic pressure is slowly increased until failure occurs. Based on the burst test results, a safety factor is applied. This establishes the ultimate pressure rating.
 Burst Testing |
Related Articles
How do I figure out the length needed for a u-bolt rod?
Added on Tue, Nov 2, 2010
What is galvanized coating?
Added on Wed, Dec 1, 2010
Why do you paint carbon steel material?
Added on Thu, Feb 17, 2011
How vital are pipe stess results to pipe support design?
Added on Thu, Nov 3, 2011
|
|