Piping Technology and Products Logo

Piping Technology & Products

  Experienced Manufacturer of Pipe Supports since 1978
Call Us: (713) 731-0030 Toll-Free: (800) 787-5914   Se habla espaƱol


FRP Wear Pad Homepage > Installation & Maintenance > FRP Wear Pad

Topic Selection:



  FRP Wear Pad


1. Clean pipe to remove scale, paint and other debris with Emrery cloth to remove sheen.

2. Use solvent to MEK solvent to remove contamination and ensure that the area is clean and dry.

3. Wipe the inside of the FRP wear pad removing dust and debris

4. Use emory cloth to rough the interior to ensure that there is a good surface for the epoxy to bond.
(See Figure 1)

5. Apply continuous bead of epoxy adhesive to the inside of the FRP wear pad.
(See Figure 2)

6. Firmly press pad in place rotating pad to spread the Epoxy out.
(See Figure 3)

7. Band FRP pad in place using band straps or ratchet straps.
(See Figure 4)

8. Apply bead of epoxy around exterior edge of FRP wear pad to ensure a complete seal.
(See Figure 5)

9. Allow 4-6 hours for the Epoxy to harden, and then remove the straps.

Using an emory cloth to rough the interior of FRP Pad
Figure 1

Applying epoxy adhesive to FRP Pad
Figure 2

Firmly press FRP pad to spread the epoxy out
Band FRP pad in place using straps Apply extra expoxy around the FRP pad Figure 3
Figure 4 Figure 5  


Mailing: P.O. Box 34506, Houston, TX 77234-4506 Location: 3701 Holmes Road, Houston, TX 77051
Our Subsidiaries: U.S. Bellows: Metallic & Fabric Expansion Joints, Bellows
Sweco Fab: ASME Vessels, Pig Launchers, Spectacle Blinds
 Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors

Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces
Phone: (713) 731-0030 Toll-Free: (800) 787-5914 FAX: (713) 731-8640 info@pipingtech.com

©2017 Piping Technology and Products, Inc. All Rights Reserved. Contact Us | Privacy Policy